Preformed Suspension Clamp for ADSS Fiber Cable

This kind of clamp is used for connection between cable and linear tower or which corner/elevation angle is less than 25 degree.
Each tower has one set.

Suspension Clamp
Fit for: Recommended space less than 100m and corner/elevation angle less than 10° , breaking strength is 10Kn, one set of fitting including one set of clamp( consisting of aluminum clamping plate and rubber pad) and a shackle.
Suspension Clamp for ADSS Fiber Optical Cables 

Short Span Suspension Clamp for ADSS Fiber Optical Cables ADSS

O-ring suspension clamp for ADSS fiber optic cables

O-ring suspension clamp for ADSS fiber optical cables is consist of high strength galvanized steel O-ring and high strength aluminum clad steel helical-formed armor rods. It can connect with U type shackle by the hole of O-ring. The armor rods can provide 20%RTS unbalanced load. It can not cause any damage to the cable by the design of end tilt and has good performance of resistance to the breeze vibration and superior fatigue properties.
For use on:
Span less than 100m, single layer
  
Tangent Suspension Clamp for ADSS Fiber Optical Cables
Tangent suspension clamp for ADSS fiber optical cables is the connection fittings for ADSS cable in transmission line for pole and tower. It can reduce the static stress at the suspension point of the cable, and raise the cable anti vibration ability, inhibition of wind vibration of dynamic stress; It can also keep the cable bending and it does not exceed the allowable numerical and the cable will not generate bending stress, so the cable optical fiber does not produce additional loss.
For use on:
Span less than 100m, no armor rods
 
For use on:
100-400 meters, 1 layer
  
 Suspension Clamp for ADSS Fiber Optic Cables ADSS

Suspension clamp for ADSS fiber optical cables can reduce the compression, clamping and bending stress of optical cable and optical fiber. At the same time, the negative effects caused by the wind, such as the wind vibration, galloping and swing, have also been reduced to the minimum.
For use on:
More than 400 meters, no more than 100 KN