Audited Supplier
Gas Treatment Device
1. A highly efficient filtering device with an advanced storage can. Typically, customers will already possess these components when undertaking treatment engineering.
2.Desulfurize device
Requirement to the Gas
1.The gas should be free of any dissociative water or other dissociative substances.
2. The gas must exhibit a thermal value of ≥5000 kcal/l. If the thermal value falls below this threshold, the generator set's power output will decrease.
3.The sulfur content must be ≤250 mg/m³. If the gas contains higher sulfur levels, it is essential to reduce this content.
Note: Excessive sulfur content can cause severe damage to engine components, thus necessitating diligent gas treatment to ensure longevity and reliability.
| Model | Voltage (V) | Frequency(Hz) | Power(kW) | Speed (r/min) | Dimension(mm) | Weight (kg) |
| AP4DG-30N5LC | 400 | 50 | 30 | 1500 | 1900×720×920 | 1000 |
| AP4DG-50N5LC | 400 | 50 | 50 | 1500 | 1900×720×920 | 1020 |
| AP4GG-60N5LC | 400 | 50 | 60 | 1500 | 1900×720×930 | 1100 |
| AP6GG-80N5LC | 400 | 50 | 80 | 1500 | 2400×980×1450 | 1200 |
| AP6GG-100N5LC | 400 | 50 | 100 | 1500 | 2400×980×1450 | 1250 |
| AP6MKG-150N5LC | 400 | 50 | 150 | 1500 | 2900×1030×1780 | 2500 |
| AP6MKG-180N5LC | 400 | 50 | 180 | 1500 | 2900×1030×1780 | 2500 |
| AP6KG-200N5LC | 400 | 50 | 200 | 1500 | 3100×1300×1780 | 3200 |
| AP6KG-250N5LC | 400 | 50 | 250 | 1500 | 3100×1300×1780 | 3200 |
| AP6TG-300N5LC | 400 | 50 | 300 | 1500 | 3200×1400×1800 | 3800 |
| AP6TDG-350N5LC | 400 | 50 | 350 | 1500 | 3270×1850×2150 | 5500 |
| AP6TFG-500N5LC | 400 | 50 | 500 | 1500 | 3600×1500×2100 | 7400 |
| AP6CG-500N5LC | 400 | 50 | 500 | 1500 | 4110×1633×2110 | 8890 |
| AP6CG-600N5LC | 400 | 50 | 600 | 1500 | 4110×1630×2110 | 8890 |
| AP12VTDG-700N5LC | 400 | 50 | 700 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-700N5HC | 10500 | 50 | 700 | 1500 | 4415×2000×2370 | 9735 |
| AP12VTDG-800N5LC | 400 | 50 | 800 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-800N5HC | 10500 | 50 | 800 | 1500 | 4415×2000×2370 | 9735 |
| AP12VCG-1000N5LC | 400 | 50 | 1000 | 1000 | 5190×2110×2660 | 16000 |
| AP12VCG-1000N5HC | 10500 | 50 | 1000 | 1000 | 5480×2110×2690 | 17000 |
| AP16VTDG-1100N5LC | 400 | 50 | 1100 | 1500 | 4620×1990×2280 | 11700 |
| AP16VTDG-1100N5HC | 10500 | 50 | 1100 | 1500 | 5480×1990×2280 | 13750 |
| AP16VCG-1500N5LC | 400 | 50 | 1500 | 1000 | 6030×2090×2745 | 22500 |
| AP16VCG-1500N5HC | 10500 | 50 | 1500 | 1000 | 6030×2090×2645 | 22610 |
| AP16VCG-2000N5LC | 400 | 50 | 2000 | 1500 | 8420×2055×2890 | 24800 |
| AP16VCG-2000N5HC | 10500 | 50 | 2000 | 1500 | 8835×2055×2890 | 25500 |
| Manufacturer of control panel | Smartgen brand HGM6120U |
| Main function | 2.Acrylic screen, improved wearable and scratch resistance property; 3.Silica-gel panel and keys can well adapt to higher and lower temperature; 4.With RS485 communication port, can achieve "three remote" functions via MODBUS protocol; 5.Adapt to 3P4W, 3P3W, 1P2W and 2P3W (120V/240V), 50Hz/60Hz AC power system; 6.Can measure and display 3 phase voltage, 3 phase current, frequency, power parameter of mains/gens; 7.Mains have functions of over/under voltage and lack of phase; Gens have functions of over/under voltage, over/under frequency and over current; 8.Precision measure and display of parameters about engine, 9.Control protection: Automatic start/stop of genset, load transfer(ATS control) and perfect failure display and protection; 10.With ETS, idle speed control, pre-heat control, speed droop/raising control, all of them are relay output; 11.Parameter setting: Allow user to modify setting and store them in internal FLASH memory. The parameters cannot be lost even when power off. All of parameters can be set not only from the front panel, but also use programmable interface (or PS485 interface) to adjust them via PC.; 12.Multi sensors of temperature, pressure and fuel level can be used directly, parameters can be defined by user; 13.Multi conditions of crank disconnect (speed sensor, oil pressure, generator) can be selected; 14.Power supply range: (8~35)VDC, accommodating to different starting battery volts; 15.All parameters use digital modulation, instead of analog modulation using conventional potentiometer, having improved reliability and stability; 16.Add rubber gasket between shell and controller screen, the waterproof can reach IP55; 17.Controller is fixed by metal fixing clips; 18.Modular design, flame-retardant ABS shell, embedded mounting, compact structure and easy installation. |
| ATS | Chinese brand together with generator |
Discover the unparalleled benefits of our single fuel gas gen sets, expertly crafted by Weifang Smart Power Generating Equipment Co., Ltd., and see how they stand head and shoulders above the competition.'Singularly designed products within the same industry:
1,Experience cutting-edge technology with the use of an advanced Hall Effect Sensor and a high-energy ignition system, ensuring exceptionally reliable ignition and effortless starting.
2,Incorporate the precision of American engineering and the excellence of British innovation to ensure our gen sets operate with unmatched reliability.
3,Optimize efficiency with gen sets capable of running in parallel and integrating into a network, enhancing total capacity and simplifying routine checks and maintenance. So operations continue seamlessly without any disruptions to customer productivity.
4,With lower engine-rated power, enjoy enhanced reliability in engine operations.
5,TMaintenance is streamlined as most spare parts are compatible with original diesel engines, easing upkeep. The spark plug'is extremely cost-effective at only2 USD each, ensuring low operational costs.
6,These gen sets boast superb economic efficiency, with minimal running expenses.
7,Benefit from gas fuel usage that minimizes carbon buildup, thereby reducing the wear on cylinder liners and gas valve seats. This enhancement prolongs the lifespan of the gen sets significantly.
8,Utilize a high-function control panel offering multi-layer protection for safe and secure gen set operations.
