ASTM A36 A572 Type B Sleeve for Oil and Gas Lines Repair

Full Encirclement Welded Split Sleeve 
Type B Sleeves :
 


 
1. PLIDCO Type Full Encirclement Welded Split Sleeves are typically used for two applications:
   pressure containing and non-pressure containing .

 A.  pressure containing 

The application is pressure containing when the split sleeves is installed over a known leak .
For a pressure containing application, the wall thickness of split sleeve and all welds must be able to contain the full operating pressure of pipeline .
The longitudinal weld joint formed by the two halves of the split sleeve must be a full thickness butt weld .
The circumferential joint formed by the split sleeves welded to pipeline must be a full thickness fillet weld . 

B. Non-pressure containing 

The application is non-pressure containing if the split sleeves is not installed over a known leak and the intended use is only to reinforce a damaged area of the pipe. 
The longitudinal weld joint formed by the two halves of the split sleeve must be a full thickness butt weld .
The circumferential joint does not have to be welded, but should be sealed with a coating to prevent ground water from penetrating the crevice between the sleeve and the pipe .
If the circumferential joint is welded, the application should be assumed to be pressure containing and all the requirements of a pressure containing application now apply .

2. PLIDO Type Full Encirclement Welded Split Sleeve are usually fabricated in length of 5 or 10 feet.
But you can define the length of split sleeve as per your own demand .
Back-up  strips for the longitudinal butt welds are furnished with all sleeves .

3. PLIDCO Type Full Encirclement Welded Split Sleeve conform to ASME B31.4 and B31.8 as well as US Department of Transportation (US DOT) requirements . Individual company codes and safety pratices should be observed .US DOT requires that population density be considered in the installation area for natural and other gas pipelines ( DOT section 192.5). Table showing maximum operating pressure PLIDCO Type Full Encirclement Welded Split Sleeve by size, materials of construction and class location are shown beside 

4. Standard body materials 
- ASTM A36
- ASTM A572 Gr.50 

Recommended Working Pressure(PSI)

Class I
Sparsely populated areas
Class II
Fringe Areas Around Urban Centers
 
Class III
Average Commercial and Residential Areas
 
Class IV
Densely Populated Areas
 
2. Project Cases :