Drying Machine Spraying Equipment, LED UV Curing Lamp, UV Curing Lamp Head

1.The UVLED light source host adopts an intelligent display screen control panel
Can independently control 1-4 channels; After the host is started, it can instantly light up the UV irradiation and freely set the power size and irradiation duration.
2.Optional 365nm, 385nm, 395nm, 405nm light sources
Customizable frequency bands according to actual needs;
Standard length 20-200mm, width 20-200mm size
The irradiation head can be customized with a special shaped luminous area according to needs.
3.This product is particularly suitable for: UV shadowless adhesive, 3D photosensitive resin adhesive, UV ink, UV varnish, blue screen printing cable reinforcement adhesive, solder joint protection adhesive, glass LCD screen repair adhesive, seamless hook bonding, medical grade catheter bonding, fluorescent testing, and more.

application

                                           Printing                                                                              Spray/Roll/Coating Industry
 

                                   Adhesive industry                                                                         Spray painting industry
                         

Attention to matters
1. Foot switch connected to interface -1/0
The OUT1-4 ports are respectively connected to control channels 1-4 to illuminate the foot switch, and CH1/GND is the reverse signal channel.
2. The irradiation connection - CH1-4 is aligned with the channel interface through the needle hole.
3. Connect the signal to the RS232 serial port
Connect the electrical signal to the RS-232 interface.
4. Source connection - DC12V
Connect the power adapter to each power interface.

1. The average service life is about 20000 hours or more;
2. Belonging to a "cold light source", the temperature rise of the irradiated surface does not exceed 5 ºC;
3. No preheating required, instantly lit, and the service life is not affected by the switch;
4. Low power consumption, only about 10% of traditional mercury lamps;
5. Imported LED beads, high energy, stable light source;
6. Pollution free production is a clean energy source.

FAQ

 

1.Provide pre-sale and after -sale technical consultation. 2.Provide 24 hours consultations technical support after sale. 3.Provide technical support for training technicians. 4.Provide technical consultation and support for mechanical equipment. 5.Provide UV equipment configuration improvement , installation proposal technical support. 6.In general, door-to-door service is not supported. If door-to-door service is required, a round-trip fee for personnel is required. 7.Normal use of the machine quality problems limited free warranty for 1 to 5 years, lifelong maintenance services, parts of the parts of the supplier to provide free on-site service.