Audited Supplier
Drilling Mud Pump
The working process of the mud pump is divided into two steps: the suction process and the discharge process.
We usually divide the mud pump into two parts: the hydraulic end and the power end. The power end is used to transmit power and convert the motion mode and speed. Provide suitable power for the hydraulic end; the hydraulic end is used to convert mechanical energy into liquid internal energy to transport mud.
The mud pump should be installed on a horizontal or slightly inclined base towards the hydraulic end (inclination ≤ 3°) to facilitate the flow of lubricating oil. Minimize the installation position of the pump and try to increase the position of the mud pit to improve the suction efficiency of the mud pump. The inlet end of the suction pipe of the pump should be about 300mm higher than the bottom of the mud pit, and the inner diameter of the suction pipe must be consistent. The inlet end of the suction pipe cannot be directly facing the inlet of the mud pit (the same applies to mud tanks). The safety valve and discharge manifold should be installed correctly according to the requirements of the instruction manual. Firmly support all suction and discharge pipelines to prevent unnecessary stress and reduce vibration, and never let pipelines hang on pumps due to insufficient support.
1.How do you transport the goods?
We transport the goods by container. we possesses long term cooperation with ship agency which can provide you lowest shipping fee. For samples we can send by express.2.Can you satisfy my special requirement?
Definitely! we have strong design capacity and R&D capacity!
3.Which shipment terms can you accept?
EXW FOB CNF CIF DDU DDP
