Audited Supplier
Gas Treatment Device
1,Filtering device, storage can (normally the customer should already have when they doing the treatment engineering)
2,Desulfurize device
Requirement to the gas
1,The gas should not have dissociative water or other dissociative substance.
2,Gas thermal value ≥5000kcal/l, if the gas is low thermal value (thermal value<5000kcal/l), then the gas gen sets power shall go dowm.
3,Sulfur content should less than or equal to 250mg/m³. if gas contents more sulfur, should get rid off sulfur content.
Note: If sulfur content is too high, it will seriously damage the engine parts.
| Model | Voltage (V) | Frequency(Hz) | Power(kW) | Speed (r/min) | Dimension(mm) | Weight (kg) |
| AP4DG-30N5LC | 400 | 50 | 30 | 1500 | 1900×720×920 | 1000 |
| AP4DG-50N5LC | 400 | 50 | 50 | 1500 | 1900×720×920 | 1020 |
| AP4GG-60N5LC | 400 | 50 | 60 | 1500 | 1900×720×930 | 1100 |
| AP6GG-80N5LC | 400 | 50 | 80 | 1500 | 2400×980×1450 | 1200 |
| AP6GG-100N5LC | 400 | 50 | 100 | 1500 | 2400×980×1450 | 1250 |
| AP6MKG-150N5LC | 400 | 50 | 150 | 1500 | 2900×1030×1780 | 2500 |
| AP6MKG-180N5LC | 400 | 50 | 180 | 1500 | 2900×1030×1780 | 2500 |
| AP6KG-200N5LC | 400 | 50 | 200 | 1500 | 3100×1300×1780 | 3200 |
| AP6KG-250N5LC | 400 | 50 | 250 | 1500 | 3100×1300×1780 | 3200 |
| AP6TG-300N5LC | 400 | 50 | 300 | 1500 | 3200×1400×1800 | 3800 |
| AP6TDG-350N5LC | 400 | 50 | 350 | 1500 | 3270×1850×2150 | 5500 |
| AP6TFG-500N5LC | 400 | 50 | 500 | 1500 | 3600×1500×2100 | 7400 |
| AP6CG-500N5LC | 400 | 50 | 500 | 1500 | 4110×1633×2110 | 8890 |
| AP6CG-600N5LC | 400 | 50 | 600 | 1500 | 4110×1630×2110 | 8890 |
| AP12VTDG-700N5LC | 400 | 50 | 700 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-700N5HC | 10500 | 50 | 700 | 1500 | 4415×2000×2370 | 9735 |
| AP12VTDG-800N5LC | 400 | 50 | 800 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-800N5HC | 10500 | 50 | 800 | 1500 | 4415×2000×2370 | 9735 |
| AP12VCG-1000N5LC | 400 | 50 | 1000 | 1000 | 5190×2110×2660 | 16000 |
| AP12VCG-1000N5HC | 10500 | 50 | 1000 | 1000 | 5480×2110×2690 | 17000 |
| AP16VTDG-1100N5LC | 400 | 50 | 1100 | 1500 | 4620×1990×2280 | 11700 |
| AP16VTDG-1100N5HC | 10500 | 50 | 1100 | 1500 | 5480×1990×2280 | 13750 |
| AP16VCG-1500N5LC | 400 | 50 | 1500 | 1000 | 6030×2090×2745 | 22500 |
| AP16VCG-1500N5HC | 10500 | 50 | 1500 | 1000 | 6030×2090×2645 | 22610 |
| AP16VCG-2000N5LC | 400 | 50 | 2000 | 1500 | 8420×2055×2890 | 24800 |
| AP16VCG-2000N5HC | 10500 | 50 | 2000 | 1500 | 8835×2055×2890 | 25500 |
| Rated Power(kVA) | 25 | ||
| Rated Voltage(V) | 400 | ||
| Rated Current(A) | 36 | ||
| Rated Freq(Hz) | 50 | ||
| Power Factor cosφ | 0.8 | ||
| Overall Size(LxWxH) | 2050*950*1750 | ||
| Net Weight (kg) | 1200 | ||
| Gross weight (kg) | 1250 | ||
| Gas Engine Model | HG4B | ||
| in line, four strokes, electric control ignition, electric starting, force water cooling, electric governor and intellectualized protection | |||
| mm Bore | 102 | ||
| mm Stroke | 120 | ||
| Cylinder Numbers | 4 | ||
| L Displacement | 3.9 | ||
| kW Rated Power | 33 | ||
| r/min Rated Speed | 1500 | ||
| Compression Rated | 11.5:1 | ||
| Start Method | Machienry starting | ||
| Firing Order | 1-5-3-6-2-4 | ||
| Cooling Method | open water cooling | ||
| Lubrication method | Pressure lubrication | ||
| 0C Working temperature | circulating water 40-85ºC lubricating oil <95ºC exhaust<650ºC | ||
| Fuel | Natural gas | ||
| oil | using Great Wall special oil or 15W/40L-ECD | ||
| Generator Manufacturer | Stamforrd | ||
| Engine Model | PI144E | ||
| Main Technical Data | 35 Rated Power 50 Rated Freq 1500 Rated Speed 400/230 Rated Volt age 0.8 Rated Factor cosφ Excitation Mooted : Brush less Phases and connecting method: three phases four lines system Self-excited alternator,automatism voltage regulation automatism heat driving off, single bearing generator Insulation class H Protection class:IP23 Voltage range of genset:±10% Steady voltage Regulation:≤±1% Transient voltage regulation:≤(-1.5-+20)% Voltage stabilization ≤1S Voltage fluctuation ratio ≤0.5% Steady Frequency Regulation:≤±1% Frequency stabilization ≤3S Frequency fluctuation ratio ≤0.5% | ||
| Manufacturer of control panel | Smartgen brand HGM6120U |
| Main function | 2.Acrylic screen, improved wearable and scratch resistance property; 3.Silica-gel panel and keys can well adapt to higher and lower temperature; 4.With RS485 communication port, can achieve "three remote" functions via MODBUS protocol; 5.Adapt to 3P4W, 3P3W, 1P2W and 2P3W (120V/240V), 50Hz/60Hz AC power system; 6.Can measure and display 3 phase voltage, 3 phase current, frequency, power parameter of mains/gens; 7.Mains have functions of over/under voltage and lack of phase; Gens have functions of over/under voltage, over/under frequency and over current; 8.Precision measure and display of parameters about engine, 9.Control protection: Automatic start/stop of genset, load transfer(ATS control) and perfect failure display and protection; 10.With ETS, idle speed control, pre-heat control, speed droop/raising control, all of them are relay output; 11.Parameter setting: Allow user to modify setting and store them in internal FLASH memory. The parameters cannot be lost even when power off. All of parameters can be set not only from the front panel, but also use programmable interface (or PS485 interface) to adjust them via PC.; 12.Multi sensors of temperature, pressure and fuel level can be used directly, parameters can be defined by user; 13.Multi conditions of crank disconnect (speed sensor, oil pressure, generator) can be selected; 14.Power supply range: (8~35)VDC, accommodating to different starting battery volts; 15.All parameters use digital modulation, instead of analog modulation using conventional potentiometer, having improved reliability and stability; 16.Add rubber gasket between shell and controller screen, the waterproof can reach IP55; 17.Controller is fixed by metal fixing clips; 18.Modular design, flame-retardant ABS shell, embedded mounting, compact structure and easy installation. |
| ATS | Chinese brand together with generator |
The advantages of our single fuel gas gen sets products produced by our company comparing with other company's products within the same area:
1,Use advanced Hall Effect Sensor and high energy ignition system to make the ignition reliable and staring more easy.
2,Use electric governor of American technology and gas regulating system of British technology to make the gen sets operating more reliable.
3,Gen sets can achieve multi sets running in parallel and combine in web, to improve total capacity and easy for gen sets to check and maintenance each time. So it will no influence the production of the customer.
4,Because the engine rated power is low, it can make the engine running more reliable.
5,The spare parts of gen sets mostly can be common used with the original diesel engine and easy for maintenance. The spark plug's price only is2usd /piece and the using cost is low.
6,There is good economic performance and running cost is low.
7,Because using gas fuel, reduce accumulated carbon, so can reduce wear and tear of the cylinder liner and gas valve seats. This can extend the life of the gen sets.
8,Using high function control panel, can achieve multi protection and make gen sets running more safe.
