Little Steed Concrete Mixer Truck

1. Body structure design
The small horse mixer uses high-strength steel as the main frame, and after precise calculation and optimization design, it ensures that the body is light and stable, can withstand the huge torque and vibration generated during the mixing process, and ensure the safety during transportation. Its unique tank design, using the principle of fluid mechanics, optimizes the mixing effect of concrete and reduces the energy consumption in the mixing process.

2. Power system configuration
The car is equipped with a high-performance diesel engine, matched with an advanced transmission system, providing sufficient power output to ensure stable mixing efficiency and driving speed under various conditions. At the same time, the engine meets environmental emission standards, reducing the impact on the environment.

1. Efficient mixing capacity
The tank of the small horse mixer truck is equipped with special mixing blades. Through the precise spiral Angle design, the efficient and uniform mixing of concrete is realized. Whether it is ready-mixed concrete or on-site batching, it can quickly achieve the uniformity and fluidity required for construction.

2. Intelligent control system
Equipped with advanced electronic control system, real-time monitoring of stirring status, engine working conditions and fuel consumption and other key parameters, users can easily adjust the mixing speed through the control panel, set the mixing time, and even achieve remote monitoring and fault diagnosis, greatly improving the convenience and safety of the operation.

1. Preparation
Before operation, it is necessary to check whether all parts of the vehicle are in good condition, including the tank, transmission system, tires, etc., to ensure that the safety lock device is effective. According to the construction needs, prepare the appropriate amount of water, cement, aggregate and other raw materials, and put them into the mixing tank according to the proportion.

2. Start mixing
Start the engine, when the water temperature and oil pressure reach the normal range, set stirring parameters through the control panel, and start the stirring procedure. During the process, pay attention to the instructions on the control panel to ensure the smooth stirring process.

3. Transportation and unloading
After the mixing is completed, drive the mixer truck to the construction site, rotate the mixing tank to the appropriate Angle as required, and use gravity or air pressure system to unload the concrete. During the discharge process, the discharge speed can be adjusted to control the flow of concrete to meet different construction needs.

1. Daily check-ups
After each use, the vehicle should be thoroughly cleaned, especially inside the mixing tank, to avoid corrosion or hardening caused by concrete residue. At the same time, check the wear of key components such as tires, brake system and drive shaft, and replace damaged parts in time.

2. Regular maintenance
Perform routine maintenance of engine oil, oil filter, air filter, etc. according to the manufacturer's recommended maintenance cycle to ensure stable engine performance. At the same time, the electrical system and control system are comprehensively inspected to prevent potential failures.

3. Storage management
When parking for a long time, ensure that the vehicle is in a dry, well-ventilated environment and avoid direct sunlight or rain. Charge and maintain the battery regularly to prevent battery loss and damage.