Audited Supplier
Gas Treatment Device
1. Filtering Device and Storage Can: Typically, customers already possess these essential components during the gas treatment process.
2.Desulfurization Device
Gas Requirements
1.The gas must be free from dissociative water and any other dissociative substances.
2. Gas Thermal Value: Should be ≥5000kcal/l. For gases with a thermal value below 5000kcal/l, note that the generator set's power output will decrease.
3.Sulfur Content: Must not exceed 250mg/m³. If sulfur content is higher, it is crucial to remove it.
Important Note: Excessive sulfur content can cause severe damage to engine components.
| Model | Voltage (V) | Frequency(Hz) | Power(kW) | Speed (r/min) | Dimension(mm) | Weight (kg) |
| AP4DG-30N5LC | 400 | 50 | 30 | 1500 | 1900×720×920 | 1000 |
| AP4DG-50N5LC | 400 | 50 | 50 | 1500 | 1900×720×920 | 1020 |
| AP4GG-60N5LC | 400 | 50 | 60 | 1500 | 1900×720×930 | 1100 |
| AP6GG-80N5LC | 400 | 50 | 80 | 1500 | 2400×980×1450 | 1200 |
| AP6GG-100N5LC | 400 | 50 | 100 | 1500 | 2400×980×1450 | 1250 |
| AP6MKG-150N5LC | 400 | 50 | 150 | 1500 | 2900×1030×1780 | 2500 |
| AP6MKG-180N5LC | 400 | 50 | 180 | 1500 | 2900×1030×1780 | 2500 |
| AP6KG-200N5LC | 400 | 50 | 200 | 1500 | 3100×1300×1780 | 3200 |
| AP6KG-250N5LC | 400 | 50 | 250 | 1500 | 3100×1300×1780 | 3200 |
| AP6TG-300N5LC | 400 | 50 | 300 | 1500 | 3200×1400×1800 | 3800 |
| AP6TDG-350N5LC | 400 | 50 | 350 | 1500 | 3270×1850×2150 | 5500 |
| AP6TFG-500N5LC | 400 | 50 | 500 | 1500 | 3600×1500×2100 | 7400 |
| AP6CG-500N5LC | 400 | 50 | 500 | 1500 | 4110×1633×2110 | 8890 |
| AP6CG-600N5LC | 400 | 50 | 600 | 1500 | 4110×1630×2110 | 8890 |
| AP12VTDG-700N5LC | 400 | 50 | 700 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-700N5HC | 10500 | 50 | 700 | 1500 | 4415×2000×2370 | 9735 |
| AP12VTDG-800N5LC | 400 | 50 | 800 | 1500 | 3850×1950×2370 | 8490 |
| AP12VTDG-800N5HC | 10500 | 50 | 800 | 1500 | 4415×2000×2370 | 9735 |
| AP12VCG-1000N5LC | 400 | 50 | 1000 | 1000 | 5190×2110×2660 | 16000 |
| AP12VCG-1000N5HC | 10500 | 50 | 1000 | 1000 | 5480×2110×2690 | 17000 |
| AP16VTDG-1100N5LC | 400 | 50 | 1100 | 1500 | 4620×1990×2280 | 11700 |
| AP16VTDG-1100N5HC | 10500 | 50 | 1100 | 1500 | 5480×1990×2280 | 13750 |
| AP16VCG-1500N5LC | 400 | 50 | 1500 | 1000 | 6030×2090×2745 | 22500 |
| AP16VCG-1500N5HC | 10500 | 50 | 1500 | 1000 | 6030×2090×2645 | 22610 |
| AP16VCG-2000N5LC | 400 | 50 | 2000 | 1500 | 8420×2055×2890 | 24800 |
| AP16VCG-2000N5HC | 10500 | 50 | 2000 | 1500 | 8835×2055×2890 | 25500 |
| Manufacturer of control panel | Smartgen brand HGM6120U |
| Main function | 2.Acrylic screen, improved wearable and scratch resistance property; 3.Silica-gel panel and keys can well adapt to higher and lower temperature; 4.With RS485 communication port, can achieve "three remote" functions via MODBUS protocol; 5.Adapt to 3P4W, 3P3W, 1P2W and 2P3W (120V/240V), 50Hz/60Hz AC power system; 6.Can measure and display 3 phase voltage, 3 phase current, frequency, power parameter of mains/gens; 7.Mains have functions of over/under voltage and lack of phase; Gens have functions of over/under voltage, over/under frequency and over current; 8.Precision measure and display of parameters about engine, 9.Control protection: Automatic start/stop of genset, load transfer(ATS control) and perfect failure display and protection; 10.With ETS, idle speed control, pre-heat control, speed droop/raising control, all of them are relay output; 11.Parameter setting: Allow user to modify setting and store them in internal FLASH memory. The parameters cannot be lost even when power off. All of parameters can be set not only from the front panel, but also use programmable interface (or PS485 interface) to adjust them via PC.; 12.Multi sensors of temperature, pressure and fuel level can be used directly, parameters can be defined by user; 13.Multi conditions of crank disconnect (speed sensor, oil pressure, generator) can be selected; 14.Power supply range: (8~35)VDC, accommodating to different starting battery volts; 15.All parameters use digital modulation, instead of analog modulation using conventional potentiometer, having improved reliability and stability; 16.Add rubber gasket between shell and controller screen, the waterproof can reach IP55; 17.Controller is fixed by metal fixing clips; 18.Modular design, flame-retardant ABS shell, embedded mounting, compact structure and easy installation. |
| ATS | Chinese brand together with generator |
The unparalleled benefits of our single fuel gas gen sets, crafted by Weifang Smart Power Generating Equipment Co., Ltd., when compared to other companies' offerings.'s products withinthe same industry:
1,Equipped with cutting-edge Hall Effect Sensors and a high-energy ignition system, our generators boast unparalleled ignition reliability and effortless start-up.
2,Incorporating the electric governor derived from American innovation and utilizing a gas regulating system based on British expertise ensures our gen sets operate with supreme reliability.
3,Our gen sets are designed for parallel operation in multi-unit configurations, offering enhanced total capacity and simplified maintenance, ensuring continuous production for clients. So there is no impact on customer production.
4,With lower engine rated power, our gen sets promise increased reliability during operation.
5,The spare parts are largely interchangeable with original diesel engine components, simplifying maintenance routines. The affordable spark plug's cost merely2 USD per piece, keeping operational expenses minimal.
6,The economic performance of our gen sets is exceptional, with low running costs.
7,By utilizing gas fuel, carbon buildup is minimized, thereby reducing wear on cylinder liners and gas valve seats. This innovation extends the lifespan of our gen sets.
8,Using a high-function control panel, our gen sets offer comprehensive protection and ensure safer operation.
