Audited Supplier
CLW5879TYDF5
Complete Vehicle
a Years
Recycling
ISO9000
6001-10000L
Euro 4
Automatic
20T
Diesel
4×2
Dongfeng
Small
Dump
New
CLW
Complete Vehicle
15 square
China
4801000000
Product Description
Introduction of the car model
The compressed garbage truck is composed of a sealed garbage box, a hydraulic system and an operating system. The whole vehicle is fully sealed. The sewage in the process of self-compression, self-dumping and compression all enters the sewage compartment, which completely solves the problem of garbage transportation.Secondary pollutionThe problem avoids inconvenience to people. The key parts are imported parts, which have the advantages of high pressure, good sealing, convenient operation, safety and so on. It can be optionally equipped with a variety of rear-hanging bucket flipping mechanisms or garbage bucket flipping mechanisms.
Chassis configuration:
Dongfeng Series 18.The compressed garbage truck adopts the special chassis of Dongfeng D9 sanitation truck, 5300MM wheelbase, Cummins 230 horsepower engine,Faster 8-speed gearbox, 10.00 steel wire tires, 2500 mmDouble-layer beam, front bridge 4.5 T,Rear bridge 10 T, exhaust brake, air cut-off brake, original factory power take-off, original factory air conditioner, national joint warranty.
Top-loading configuration table:
The compressed garbage truck is composed of a sealed garbage box, a hydraulic system and an operating system. The whole vehicle is fully sealed. The sewage in the process of self-compression, self-dumping and compression all enters the sewage compartment, which completely solves the problem of garbage transportation.Secondary pollutionThe problem avoids inconvenience to people. The key parts are imported parts, which have the advantages of high pressure, good sealing, convenient operation, safety and so on. It can be optionally equipped with a variety of rear-hanging bucket flipping mechanisms or garbage bucket flipping mechanisms.
| Project | Parameter | Remarks |
| The whole vehicle model | HCQ5072ZYSJX6. | Jiang Ling |
| Chassis model | JX1071TG26. | Jiang Ling |
| Wheelbase | 3360 | (Mm) |
| Engine | Jiangling 115 | Country VI emissions, diesel engine |
| Gearbox | .6 gears | Getrak |
| The effective volume of the box | 6 squares | (M3) |
| External size | 6800,6620,6360×2090×2650 | (Length × Width × Height) (mm) |
| Quality of preparation | 5400 | (Kg) |
| Maximum total mass | 7300 | (Kg) |
| .Mode of operation | PLC / CAN | Electronic control/manual/remote control |
| The method of loading | Manual/Automatic | Flipping frame, floor bucket, triangle bucket, swing arm, |
| Adaptable trash can | 120 liters/240 liters/660 liters | |
| Skateboard structure | Photoelectricity | External skateboard, built-in skateboard |
| One feeding cycle time | 15 to 30 | (Small size) |
| Unloading time | ≤35 | (Small size) |
Chassis configuration:
Dongfeng Series 18.The compressed garbage truck adopts the special chassis of Dongfeng D9 sanitation truck, 5300MM wheelbase, Cummins 230 horsepower engine,Faster 8-speed gearbox, 10.00 steel wire tires, 2500 mmDouble-layer beam, front bridge 4.5 T,Rear bridge 10 T, exhaust brake, air cut-off brake, original factory power take-off, original factory air conditioner, national joint warranty.
Top-loading configuration table:
| Order | .Name | Specifications and models |
| 1 | Chassis name/model | Dongfeng D9 series |
| 2 | Wheelbase (mm) | 5300 |
| Three | The volume of the box is m3 | 18(Ensure that the standard 240L trash can can be loaded360 to 380Barrel) |
| 4 | Box thickness mm | .Wugang Q345 low-alloy manganese steel (side five and bottom five) flipping mechanism scraper, arc bottom plate, slide adopts Q710 high-strength plate |
| 5 | Sewage tank | There is a sewage sink on the front of the large box, and an integrated sewage tank at the bottom of the filler. |
| 6 | Box shape | Arc, the side plate is the whole plate for one-time molding, no welding |
| 7 | Hydraulic cylinder | Hengli |
| 8 | Oil pump | Changyuan |
| 9 | .Multi-way valve | Yangzhou Jiangyan 3+2 multi-way valve |
| Ten | Hydraulic oil pipe | Bonway hydraulic oil pipe |
| 11 | System rated pressure | 18 MPa |
| 12 | Compression ratio | ≥0.85 |
| 13 | Consolidation method | Two-way peristaltic compression |
| 14 | Control system | German Siemens PLC and German photoelectric sensors |
| 15 | Loading single cycle time | ≤24 s |
| 16 | Time to dump garbage | ≤35 s |
| 17 | Control method | All-in-one independent operation of the handsplet (standard remote control) |
| 18 | Key component structure | Reinforced with cast steel parts |
| 19 | Shovel and skateboard slider | Highly wear-resistant nylon |
| 20 | .The design of the whole vehicle | Use SW three-dimensional software to simulate |
| 21 | Back-hanging bucket method | Standard configuration: rear-turning barrel type (can hang the national standard 240 plastic barrel or iron barrel or triangle bucket) / optional: fully sealed bucket, swing arm flip |
| 22 | Body color/text | Body color and text painting can be customized according to customer requirements. |
| 22 | Attachment | Profile light, side light, work light |
| Highlights of the car model | ||
| 1 | Larger loading capacity: | Compared with the previous generation, the load capacity of the same volume is increased by 5% per square (more than 7 barrels of 240L trash cans). |
| 2 | Easy fault position: | The force position of the scraper skateboard is generally prone to deformation, resulting in unstable work. The new generation of products developed by our company has been innovative in terms of materials and design, making the performance of the whole vehicle more stable and improving the service life. |
| Three | Working hours: | The loading time of the new generation of compressed garbage trucks produced by our company is within 25 seconds in the idle state, and the loading time is the longest time used by the vehicle, so it is fuel economy, reduces costs, and improves work efficiency. |
| 4 | Wear parts: | The scraper is the largest force on the vehicle, and the slide is the most worn. Our company's slide adopts a high-strength Q710 of more than 8mm, and the middle of the scraper is strengthened separately, which has greater bearing capacity and stronger wear resistance, which greatly increases the service life. |
| 5 | Oil pump: | The oil pump is the main component of the compression vehicle. Our company's new generation of oil pumps is customized for oil pump factory, with stable performance and extremely low failure rate. |
| 6 | Noise: | The new generation of compressed vehicles has added a photoelectric induction device, which can control the travel distance of each action, reduce the metal sound generated during collision and scraping, and effectively improve noise pollution. |
