Audited Supplier
1. Conductor Material
Paper-covered copper twisted wire used 12.5mm Oxygen-free copper rod, alloy grade TU2, copper content ≥99.95%.
2. Insulation Thickness
1.0mm
2.0mm
3.0mm
4.0mm
5.0mm
6.0mm
8.0mm
10.0mm
According to the customer request
3. Standard
GB/T 7673.3
IEC 60317-27
Customer Standard
4. Specification
Nominal cross-section/mm² | Core structure | Nominal cross-section/mm² | Core structure |
10 | 12×7/0.39 | 125 | 27×12/0.70 |
16 | 12×7/0.49 | 150 | 14×19/0.85 |
25 | 19×7/0.49 | 160 | 27×12/0.80 |
35 | 19×7/0.58 | 185 | 27×12/0.85 |
50 | 19×7/0.68 | 200 | 37×12/0.75 |
70 | 27×7/0.68 | 250 | 37×12/0.85 |
80 | 37×7/0.62 | 300 | 27×19/0.85 |
95 | 37×7/0.68 | 315 | 37×19/0.75 |
100 | 37×7/0.70 | 400 | 37×19/0.85 |
120 | 27×12/0.68 | 500 | 37×19/0.95 |
Specifications beyond the above range, please contact us
Transposed conductor refers to the combination of a number of enameled copper flat wires into two rows with wide surfaces in contact with each other, and according to the requirements on the top and bottom of the two rows of enameled wires along the narrow side of the same direction of transposition, and electrical insulation tape is used. As a multi-layer continuous and tightly wrapped composition
The windings of large power transformers use transposed conductors, which can greatly reduce load loss, reduce the temperature rise of winding hot spots, improve the mechanical strength of windings, make the structure more compact, and make coil processing easier. It is widely used in winding design and manufacture.
In the production process of transposed conductors, there will be a problem of poor external dimensions of the transposed conductors. It is often found after the next process that it is irreversible, so that the product cannot be reordered. Winding process processing, adjusting the insulation structure affects the efficiency and product quality. Therefore, it is urgent to solve the existing problems of the large width and height of the transformer winding transposition wire, which is to solve the unqualified quality problem that the wire causes the transformer coil radial and lateral diameter to increase.
