Audited Supplier
dp-2"
Drainpipe, Water Supply Pipe, Threading Pipe, Wire
PVC Fiber Braided Hose
30m/50m/100m
2mm-7.5mm
3bar-20bar
19mm-406mm
Durable,High Pressure,Weather Resistant
Water, Oil,Air
Food Grade, No Toxic Grade, No Smell Grade
9bar-60bar
Plant, Farm, Construction, Mining and Family
High Strength Fiber
TAIJI
Transparent Plastic Film Wrapped
1.2*1.2*2
Qingdao
391739000
Product Description
wellpoint dewatering filter pipe
What is Wellpoint Dewatering?
A Wellpoint Dewatering system is a versatile, cost-effective pre-drainage solution that features individual wellpoints which are closely spaced around the excavation.
This technique utilizes vacuum to assist in lowering groundwater levels to create a stable, dry working environment. Wellpoints are especially suited to shallower excavations or excavations taking place in fine-grained soils.
This technique utilizes vacuum to assist in lowering groundwater levels to create a stable, dry working environment. Wellpoints are especially suited to shallower excavations or excavations taking place in fine-grained soils.
Wellpoint System Design
Wellpoint systems consist of a series of small-diameter wellpoints installed at a pre-determined depth (usually 23ft deep or less) on relatively close centers. They are quick to install & can handle a wide range of flows.
The pump serves three basic functions:
- Creates vacuum & primes the system
- Separates air/water
- Pumps water to the discharge point
Wellpoint Installation
- Pumps vacuum filter for wellpoint dewatering made from special shock resistant PVC pipes. The filter has a diameter of 50 mm and is equipped with 0.3 mm perforation at the bottom with a perforation length of one metre.
Water filter pipe for well point dehydration,2. Outer diameter 1-3/4 inch,2 inches, wall thickness 2mm,2.4mm; The length is 4 meters,5 meters,6 meters,7 meters, the lower end of the slit, the width of the cutter is 0.3 mm,0.5 mm,0.8 mm, the direction of the slit is transverse and longitudinal, the gap between the slit and the slit is 4 mm,3. Sleeve type, with thin tubes inside,
Single & Multi-Stage Systems
Wellpoint systems are limited by suction lift and can only lower water below grade to a certain point (depending on the altitude). Systems are often installed as a Single-Stage or Multi-Stage because of these limitations:Single Stage
When excavations are 18ft deep or shallower, one row of wellpoints may be used to draw the groundwater below subgrade. Careful consideration should be given to the project altitude as higher altitudes will mean less available drawdown.
Multi-Stage
Wellpoints can be used on much deeper excavations, but multiple stages are required. If necessary, two or more rows of wellpoints are installed at different elevations. This is needed when the excavation is deeper than 18ft or when the altitude would prevent dewatering with a single wellpoint stage.
Advantages & Limitations
Advantages
Advantages & Limitations
Advantages
- Quick installation & easy maintenance
- Cost-effective
- Used in low & high permeability soilds
- Suited for shallow aquifers
- Limitations
- Deep excavations (due to suction lift limits)
- Lowering water table near bedrock
-
Qingdao Dewatering Pump Manufacturing Co., Ltd.one of the leading manufacturers of dewatering pumps, recommends two types of wellpoint pumps - rotary and piston. With rotary wellpoint pumps, a vacuum is created by the rotation of a pair of rotors inside the pump housing. As the rotors mesh a cavity is formed at the inlet of the pump drawing liquid into the housing. As the rotors rotate, the liquid is carried in the pockets formed between the rotors and housing where the meshing of the rotors compresses the liquid and forces it out of the discharge port.
1. Ensure product quality. We have been selling products for many years now.
2. Ensure that customers receive packages safely without customs problems.
3. Long term cooperation with customers to solve problems for customers.
